5/11/2021 0 Comments Download Free Airvac Zx6000 Manual
Be sure to have the exact model number, serial number, and the nature of the problem ready.The Platinum Series central vacuums contain a Model VMP600 slide-gate collar dust bag that is installed inside the debris bucket.The debris level in the dust bag is indicated by the front panel display of the vacuum.
The dust bag should be replaced when the red bars of the bag level indicator light (bag full). Regular dust bag replacement will enhance performance and conform to the terms of the product warranty. The dust bag inside the debris bucket should be replaced ve to six times a year under normal use. The Platinum Series vacuums contain a self-cleaning inverted cloth lter. When the power unit is running, the cloth lter is pulled upward inside the vacuum body. When the power unit is turned off, the weighted center of the lter causes it to drop, depositing dirt and dust past the dust cone and into the debris bucket. The inverted cloth lter should not be removed for any reason except to replace it if it becomes damaged or torn. To replace the dust bag, follow these easy steps: 1 Make sure the power unit is disconnected from the electrical wall outlet. Swing the two bucket slide latches down to lower the debris bucket. Remove the debris bucket from the slide latch hangers. Remove the dust bag from the debris bucket and pull on the bags slide-gate to seal the bag. Dispose of the dust bag in a refuse container. Use your hand to expand the bag of a new VMP600 dust bag and place it into the debris bucket. Reach into the dust bag again and expand the bag against the sides of the debris bucket. Reattach the debris bucket on to the slide latch hangers. Swing the two bucket slide latches up to raise and seat the debris bucket. Reconnect the power unit to the electrical wall outlet. Press the RESET button for seven seconds to reset the bag indicator. Emptying a Red Series Central Vacuum Power Unit Bagless Red Series The debris bucket is the removable lower section of the power unit. The debris bucket is semi-transparent, the dirt level can be seen through its sides. The debris bucket in the Red Series central vacuum must be checked periodically and emptied when it becomes 34 full. Regular emptying will enhance performance and conform to the terms of the product warranty. Dirt and debris are deposited in the debris bucket and it should be emptied ve to six times a year under normal use. The Red Series bagless vacuums contain a self-cleaning inverted cloth lter. When the power unit is turned off, the weighted center of the lter causes it to drop, depositing dirt and dust into the debris bucket. ![]() Remove the debris bucket from the slide latch hangers and empty the bucket into a refuse container. ![]() Push circuit breaker reset button on the power unit. Check the panel circuit breaker that connects the power unit. If the breaker trips again, call your AirVac dealer for service. AFTER CHANGING OF THE BAG (PLATINUM SERIES ONLY) 1 Push down the RESET button for seven seconds to reset the bag indicator. IN CASE OF LOW VACUUM POWER 1 Be sure that the inlet plug is inserted into the unused power unit intake port. Check that all wall valves are closed. Check that all gaskets on wall valves are sealed. Check to see if debris bucket or bag (Platinum Series only) needs emptying. Check for obstructions in the hose, tools, or vacuum lines. Check for any ruptures or breaks in the vacuum duct system. If you encounter any problems with your equipment, verify the operation against the information contained in these instructions. ![]()
0 Comments
Leave a Reply. |